| Home | Terms | Order | Contact Us | Catalog | Information | About Us |
Installing The Fill Station
- Always secure your source CO2 cylinder to a fixed structure. Its the law.
- Make sure seal washer is in CGA 320 nut.
- Tighten CGA 320 nut to male stem of source cylinder.
- Make sure fill valve is closed.
Filling the Paint Ball CO2 Cylinder
- Inspect the customers paint ball cylinder and the white seal o-ring for damage. Never fill damaged paint ball paint ball cylinders.
- CO2 can cause frost burns so always wear gloves.
- Screw paint ball cylinder valve into universal fill adapter. Be sure not to cross-thread!
- Determine proper number of ounces of liquid to be flowed into paint ball cylinder. (ie: 31/2, 7, 9,10, 12, 16, 20, etc.)
- Open bleed valve by turning handle in line with body of valve.
- Screw universal fill adapter's pin depressor clockwise until CO2 begins to blow out.
- When all CO2 has escaped from paint ball cylinder, close bleed valve. Always close bleed valve before opening main fill cylinder.
- Open source cylinder valve by turning to th full counterclockwise position and remember to watch scale. The scale (not counting like a "Know-it-All") is the only way to know when the cylinder is full!
- When proper amount of CO2 has entered bottle, close source cylinder valve. Never overfill paint ball paint ball cylinders. Overfilling wil cause blowout disk to rupture.
- Turn universal fill adapters pin depressor knob counter clockwise until it releases pressure on cylinder pin.
- Open bleed valve to relieve the pressure in the line.
- Unscrew paint ball cylinder.
- Tile Only Way To Measure (Ills Is With A Scale! For Best Results, Use Siphon Tubes Source Cylinder.
CAUTION : before using any CO2 cylinder before checking the DOT date stamp to be sure paint ball cylinder is properly tested. Never fill out of date paint ball cylinders.
Return to Fill Station Page |
Return to Top of Page. Copyright © 1996 - 2007 Crossfire Engineering Inc.
|
