HomeTermsOrderContact UsCatalogInformationAbout Us


Off-taste beer is often bitter and bitey, sometimes completely lacking in flavor and zest. The beer may also have an oily or foul order with a very unpleasant taste.

Causes of off-tasteRequired Correction
Improper cleaning.Coils, faucets, keg connectors, hoses, rods, fittings, seals and check valves should all be cleaned once a week with B*L*C* or an other approved cleaner.
Beer line is not brewery approved or stainless steel.Replace with stainless steel or brewery approved vinyl beer line.
Dirty pressure lines.Hoses and vents should be inspected and if contaminated they should be replaced.
Improper pressure hose.Replace rubber hoses with Vinyl air line Number 7080 tubing.
Unfiltered air.Air must always be filtered. Install a charcoal filter in the air outlet and a hair felt inlet filter to the compressor.
Contaminated air.Air must be filtered and moisture traps installed and drained daily.

Draft Problems are usually very simple and easily fixed when you understand the facts. The links on this page will allow you to both set up your draft system and trouble shoot a system that has gone bad.

Before you get into trouble shooting a system make sure of following things:
Is the system Balanced?
Is the beer keg internal temperature below 42°F.?
Is your regulator gauge pressure set at the proper Pressure for the keg temperature?
Remember that all these parameters have been worked out over several hundred years and each parameter is very important in serving a perfect draft.

Select the page below for th problem you are experiencing:
I have Cloudy Beer!
I have Flat Beer!
I have Foul Beer!
I have Sour Beer!
I have Wild (foaming) Beer!
I have Tail End Beer!

 

Return to Top of Page.

 

  Copyright © 1996 - 2007 Crossfire Engineering Inc.
 
Webmaster